Service Engineer

Contenuto del lavoro

Responsibilities

• Help customer debug and repair for PCB in customer site.
• On site replace and solder the parts
• On site debug and change the KITs
• Capable of using manual measurement equipment (Meter, Scope, Spectrum… etc.) as required.
• Analyze problems and recommend solutions.
• Writing related verification and engineering report as required.
• Run the ATE test program or DIB diag program help to check where is the PCB fail.
• Work with customer for the device bring up support.
• Help customer check the schematic and layout find out the failure trace and parts.
  

( Location : Kaohsiung )

Basic Qualifications & Skills

• 2 years above IC test, PCB Service, ATE equipment, software engineer experience is plus.
• Ability to work in a team environment.
• Good attitude & cooperation
• Good communication Skills is plus.
• Bachelor’s degree in engineering, EE, computer science, or computer engineering or related fields.
• Knowledge of Device-Interface Probe Card, Load board Debugging/Repair is plus
• RF test debug and test Knowledge
• Strong analytical skills and practical problem-solving skills is plus
• Drive the car to ship the board back and return for customer.
• Ability to understand the P/C and L/B design schematic and Layout.
• Familiar with Teradyne tester, such as J750, Ultraflex, UltraFlex Plus, Eagle ATE experience is plus
• Familiar with Design Tool , OrCAD Schematic & Allegro PCB layout is plus
• Good written and verbal communication skills in English is plus
• Familiar with Visual Basic is plus
• Must be willing to work overtime and support with different location.
  

Education

Bachelor or higher degree in EE or related fields